The Kymera magic wand remote control has revolutionized the way people control all the electrical devices in their home. With its wand-like shape it let's users feel like harry potter every time they change channels. You may be someone who has recently purchased one of these amazing devices. You may also be someone who has seen it on YouTube and it is now on your list of must-have gadgets. Either way there may be one question burning in your mind about this. How do you save command on this?
The magic wand remote control can record up to 13 different gestures for controlling functions on different devices. These gestures vary from rotate clockwise or anti-clockwise to flick up or flick down. They allow different functions to occur such as adjusting volume or changing channel. The wand works by copying infra-red signals from the electrical devices. This is a pattern of light that sends simple instructions to the receiver units on your electrical goods.
However, you must use different gestures for each function in order to avoid more than one device being activated at the same time. You must therefore tell the wand that that's the command you want for that particular gesture.
So how do you teach the want to learn a new command?
Firstly you need to put the wand in save mode. This is done by holding it with the tip facing upwards and tapping it twice with your finger. The wand will then vibrate to tell you it is ready to learn a new gesture. Once you have performed the new gesture the wand will vibrate again to tell you that command has been stored.
You can also copy commands from your existing remote control. Simply press the button on the manufacturer's remote you wish to copy and point this towards the tip of the wand. Once you have done this point the wand downwards and tap once with your finger to save this command.
ไม่มีความคิดเห็น:
แสดงความคิดเห็น